Cotek S600R Series Manual do Utilizador

S600,S600R Series Pure Sine Wave Inverter User’s Manual

3-2-2. Ventilation window： Do not obstruct, allow at least 3 inch for proper air flow. 3-2-3. Input terminals： Connect to 12v / 24V / 48V battery or

3-3. Installation： Where to install. The power inverter should be installed in a location that Meets the following requirements： 3-3-1. Dry – Do n

3-4. Quick hook – up and testing： For a quick hook – up of the power inverter to check its performance before going ahead with installation, please f

3-4-3. Before proceeding further, carefully check that cable you have connected does tie negative terminal of inverter to the negative output power s

3-5. AC Safety Grounding： During the AC wiring installation, AC input and output ground wires are connected to the inverter. The AC input ground w

Ground Fault Circuit Interrupters (GFCI)： Installations in Recreational Vehicles (for North American approvals) will require GFCI protection of all b

Increasing your DC cable size will help improve the situation. Cotek recommends the following cables for optimum inverter performance ( apply both 12

3-7. Inverter Operation： To operate the power inverter, turn it on using the ON / OFF switch on the Front panel. The power inverter is now ready t

4. Troubleshooting guide： WARNING! Do not open or disassemble the S600 Inverter. Attempting to service the unit yourself may result in a risk of elec

5. Maintenance： Very little maintenance is required to keep your inverter operating properly. You should clean the exterior of the unit periodically

List of contents 1. Important Safety Instructions……………………………………………… 1 1-1 General Safety Precautions…………………………………………… 1 1-2 Precautions When Wo

7-1. CE (LVD EN60950) Declaration of Conformity： 18

7-2. FCC (Class B) Declaration of Conformity： 19

7-3. e-mark (e13 020866) Declaration of Conformity： 20

7-3. e-mark (e13 020866) Declaration of Conformity： 21

7-4. UL (UL458) NOTICE OF COMPLETION22

1. Important Safety Instructions WARNING! Before you install and use Your Inverter, be to read and save these safety instructions. 1-1. General

2. Features Pure sine wave output (THD < 3%) Output frequency：50 / 60Hz switch selectable Input & output fully isolation design High effic

2-2. Electrical Performance Specification Model No. Item S600-112 S600-124 S600-148 S600-212 S600-224 S600-248Continuous Output Power 600W Maximu

2-3. Mechanical Drawings PURE SINE WAVE INVERTER4

3. Introduction This power inverter series is a the member of the most advanced line of mobile AC power systems available. To get the most out of the

3-1-4. Load Level：Display AC Load Watts LED Status Load Condition Dark 0 ~ 30W Green 30W ~ 200W Orange 200W ~ 450W Red 450W ~ 580W Red Blink Ov

3-2. Rear Panel Operations： WARNING: REVERSE POLARITY WILL DAMAGE UNITCHASSISGROUNDREMOTE PORTDC INPUTNEG(-) POS(+)POS(+)DC INPUTWARNING: R