Cotek S600R Series Manual do Utilizador descarregar pdf (Página 11)

3-3. Installation：

Where to install. The power inverter should be installed in a location that

Meets the following requirements：

3-3-1. Dry – Do not allow water to drip or splash on the inverter.

3-3-2. Cool – Ambient air temperature should be between 0℃ and 33℃, the

cooler the better.

3-3-3. Safe – Do not install in a battery compartment or other areas where

flammable fumes may exist, such as fuel storage areas or engine

compartments.

3-3-4. Ventilated – Allow at least one inch of clearance around the inverter

for air flow. Ensure the ventilation openings on the rear and bottom

of the unit are not obstructed.

3-3-5. Dust – Do not install the Inverter in a dusty environments

where are dust, wood particles or other filings/shavings are present.

These dust can be pulled into the unit when the cooling fan is

operating.

3-3-6. Close to batteries – Avoid excessive cable lengths but do not install

the Inverter in the same compartment as batteries.

Use the recommended wire lengths and sizes (see section 3-6).

Also do not mount the Inverter where it will be exposed to the

gases produced by the battery.

These gases are very corrosive and prolonged exposure also will

damage the Inverter.

WARNING!

Shock Hazard. Before proceeding further, carefully

check that the Inverter is NOT connected to any

batteries, and that all wiring is disconnected from any

electrical sources. Do not connect the output terminals

of the Inverter to an incoming AC source.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Cotek S600R Series Manual do Utilizador Página 11